How much air is (minimum) needed to run the fusion cs and two ipm-02 pumps? My compressor just went down and I need to get a spare compressor going asap before this one is replaced. I know the gun requires 90psi and we run the pumps at 80-90 psi
I have a Graco h-35 pro with 300 feet of hose and a 10 foot whip.I am trying to find out why the breaker for the hose heat keeps tripping. When I start it heats up just fine... While I am spraying foam I have the heat set around 120 F. I can spray f
Has anyone tried something different other than the chemtrend pura insulation release? How are you using it? Guns? masks? molds? Does it leave a film behind?
We have always used Ap fusion guns in both rigs, and don't have any problems. I've never used anything else and was wondering if there is a better gun out there for what we do. Always roof application, and always 3.0 foam.
string(25) "> No debug data available"